Retrotec Blower Door Bedienungsanleitung PDF herunterladen (Seite 30)

Page 30 of 87

©Retrotec Inc. 2015

Additional panels, including a Small-X panel, can be purchased to increase the maximum doorway height that the

modular panel is capable of filling.

Overall outside dimensions (OD) for the Modular panels:

Model:

PN201

Type of Panel:

Hard Panel (Single Fan)

Width (min/max):

32” – 48.75” (81 - 124 cm)

Height (min/max):

76.5” - 87” (194 - 221 cm)

Panel Case (included):

31” x 30” x 7” (79 x 76 x 18 cm)

PN210R Large X-Panel: 27 ¾”H x 29 5/8”W closed, 51”W open

PN211 XY Panel: 19 ½”H x 29 5/8”W closed, 52”W x 30” open

PN207 Large Fill-in Sheet for Fan Panel: 27”H x 17 ½”W OD

PN208 Small Fill-in Sheet for Fan Panel: 26”H x 4 ½”W OD

A Field Verification Plate and a Blanking Plate are available for insertion in the holes of the Modular Door Panel, to

run a verification of the calibration of the system and cover any non-needed holes in Fan Panels. See details in

Appendix C.

A Weather Strip replacement kit is also available.

3.2.1. Modular Door Panel Instructions

For detailed instructions on installing the Modular Door Panel, see the Modular Door Panel Quick Guide.

To install the Modular Door Panels

1. Unpack the panels. The Fan Panel is installed first. Place it in the doorway, touching the ground. All panels

should expand towards the door hinges. The panels can be expanded by pulling the yellow cords tight, and

then securing the cord on the cleat. Do not secure the yellow cords on the Velcro, to hold the straps tight.

The Velcro is only meant to hold the straps against the panels. Attach the fan strap.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 86 87

Keine Kommentare

Retrotec Blower Door Bedienungsanleitung Seite 30